Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

not able to assign static ip after cable source verify dhcp

After we configured cable source verify dhcp on our cmts,,, we are not able to assign static ips to cep devices behind pix at offices.. can some help us out with this

thnx

2 REPLIES
Hall of Fame Super Silver

Re: not able to assign static ip after cable source verify dhcp

Hello Devi,

have the IP addresses assigned by DHCP so that the security check is passed.

On the DHCP server configure it to provide reservations to specific users that you want to have a persistent IP address (tied to the NIC MAC address)

OR

remove the security check command

cable source verify dhcp

that asks to verify source IP addresses against DHCP database (for this reason you cannot assign IP addresses statically to your CPE devices)

Hope to help

Giuseppe

New Member

Re: not able to assign static ip after cable source verify dhcp

Hey

Thank you so much for your reply.

We have site to site tunnel for many offices and with sticky IP (from dhcp server) we need to change the IP at the firewall we have to bring the tunnel up and to avoid these issues, we are using static ips but,, they are fine but we started configuring our cmtses with cable source verify dhcp and we are not able to assign static Ips....

thnx

308
Views
0
Helpful
2
Replies