Not able to configure "dual-active detection bfd" in Cisco 6500 VSS switch
i am not able to configure the command dual-active detection bfd in cisco 6500 VSS switch.
Trying to configure the bfd between two switches having a direct connectivity between two switches physically by an gig int. ...
Here is the attempt given below,
PDC2-S4-VSS-C6506#conf t Enter configuration commands, one per line. End with CNTL/Z. PDC2-S4-VSS-C6506(config)#switch virtual domain 100 PDC2-S4-VSS-C6506(config-vs-domain)#dual PDC2-S4-VSS-C6506(config-vs-domain)#dual-active ? detection Dual-active detection enable exclude Dual-active cmd to exclude interface from shutdown in recovery mode
sh version Cisco IOS Software, s2t54 Software (s2t54-IPSERVICESK9-M), Version 15.0(1)SY4, RELEASE SOFTWARE (fc3) Technical Support: http://www.cisco.com/techsupport Copyright (c) 1986-2013 by Cisco Systems, Inc. Compiled Mon 18-Mar-13 00:26 by prod_rel_team
ROM: System Bootstrap, Version 12.2(50r)SYS3, RELEASE SOFTWARE (fc1)
PDC2-S4-VSS-C6506 uptime is 3 days, 21 hours, 14 minutes Uptime for this control processor is 3 days, 21 hours, 16 minutes System returned to ROM by reload at 10:20:11 UTC Mon Oct 28 2013 System image file is "bootdisk:s2t54-ipservicesk9-mz.SPA.150-1.SY4.bin" Last reload reason: Conversion
This product contains cryptographic features and is subject to United States and local country laws governing import, export, transfer and use. Delivery of Cisco cryptographic products does not imply third-party authority to import, export, distribute or use encryption. Importers, exporters, distributors and users are responsible for compliance with U.S. and local country laws. By using this product you agree to comply with applicable laws and regulations. If you are unable --More-- to comply with U.S. and local laws, return this product immediately.
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...