Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not able to connect to ISDN Interface

Hi Experts,

Need your help. I have configuration as below AND ALSO debug log at the bottom. NO matter what I have done , I still cant get it up.

- I have username/password of the other end router configured.

- I have the dialer protocol permit ip list

I can;t think off anything more. Need your advise.

Thanks!

CONFIGURATION of the routers :

interface Dialer10

ip address 172.2.24.202 255.255.255.252

ip nat inside

ip virtual-reassembly

encapsulation ppp

no ip mroute-cache

dialer pool 1

dialer idle-timeout 300

dialer enable-timeout 5

dialer string 64410114

dialer caller 64410114 callback

dialer load-threshold 200 either

dialer-group 1

no cdp enable

ppp authentication chap

ppp multilink

DEBUG LOGS at attached.

3 REPLIES
Bronze

Re: Not able to connect to ISDN Interface

Hello,

The debug logs show traffic going to Dialer15 however the config you've pasted is for Dialer10. Is the traffic being routed to the wrong dialer interface? If not please upload new debug of the correct traffic.

Regards

New Member

Re: Not able to connect to ISDN Interface

SOrry..the router config is correct.

Is Dialer 15.

Hall of Fame Super Silver

Re: Not able to connect to ISDN Interface

Hello Cindy,

you have configured ppp authentication chap.

you need to configure it on both the dialer and the physical interface

to see possible PPP problems use

debug ppp negotiation

debug ppp authentication

you need also a username remote-hostname password passw

the password must be the same on both sides

Hope to help

Giuseppe

96
Views
0
Helpful
3
Replies