Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

Not able to setup pri-group in controller T1 0/0/0

I have a remote site with a VWIC2-2MFT-T1/E1 Module in a Cisco 2811 router. They are trying to configure a PRI group underneath the controller interface. However the command is not being accepted. Customer has added the ISDN switch type statement (isdn switch-type primary-5ess)in the global area. The following error is generated when configuring "pri-group timeslots 1-24".

pri-Group statement is not available underneath the controller interface

Serial interfaces are not available either. The IOS is 12.4(9)T6. I found a bug similar to this issue but was in 12.2 code.

3 REPLIES
Hall of Fame Super Silver

Re: Not able to setup pri-group in controller T1 0/0/0

Richard

What if they try configuring channel-group instead of pri-group

HTH

Rick

New Member

Re: Not able to setup pri-group in controller T1 0/0/0

controller T1 1/0

framing esf

linecode b8zs

cablelength long 0db

pri-group timeslots 1-24

do you want to try this on global config?

New Member

Re: Not able to setup pri-group in controller T1 0/0/0

Hey Guys,

I just got more information that changes the whole thing. I found out they are seeing the following error:

% Not enough DSP resources available to configure pri-group on controller T1 0/0/0

There are no PVDMs because they just want to do ISDN. I had them use an IOS with only the IP BASE feature to take away the voice support. This fixed the issue.

Sorry, I was not aware at the time that it was bogus information.

Thanks for the help, anyway.

247
Views
5
Helpful
3
Replies