Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

not booting 3745 router

Hi

I have a 3745 router with CE Module

when I start power on , then after the message the router not boot. same result arise after without CE module also.

so what is the problem ?.

--------------------

Bootstrap version 12.2 (8r)T2

program load complete, entry point: 0x80008000, size: 0x1172120

Self decompressing the image : #################################################

################################################################################

########################################################################### [OK]

Smart Init is enabled

smart init is sizing iomem

ID MEMORY_REQ TYPE

0002F7 0X005F3C00 C3745 Mainboard

0X00280000 OIR memory

0X000F3BB0 public buffer pools

0X00211000 public particle pools

TOTAL: 0X00B787B0

If any of the above Memory Requirements are

"UNKNOWN", you may be using an unsupported

configuration or there is a software problem and

system operation may be compromised.

Rounded IOMEM up to: 12Mb.

Using 9 percent iomem. [12Mb/128Mb]

-----in here stop not booting

thanks

Biplob

5 REPLIES

Re: not booting 3745 router

Did you execute an IOS upgrade when this started to occur?

Regards,

Leo

Re: not booting 3745 router

Did you execute an IOS upgrade when this started to occur?

Regards,

Leo

Re: not booting 3745 router

Make sure the memory module is seated properly. If memory had been confirmed, it is likely the IOS had been corrupted.

New Member

Re: not booting 3745 router

Thanks. I check it.

New Member

Re: not booting 3745 router

hi

i replace the RAM slot but still sam eproblem and also IOS change.

Thanks

biplob

128
Views
0
Helpful
5
Replies
CreatePlease to create content