Upgraded Frac T1 from 768 to full T1 1544.Sub interface shows 768k.The main interface shows 1536. Any suggestions on how to verify actual bandwidth so I can go back to the Telco Provider and make them fix? Thanks in advance.
no ip address
encapsulation frame-relay IETF
service-module t1 timeslots 1-24
interface Serial0/3/0.1 point-to-point
ip address 172.16.0.38 255.255.255.252
no cdp enable
frame-relay interface-dlci 712
Serial0/3/0 is up, line protocol is up
Hardware is GT96K with integrated T1 CSU/DSU
MTU 1500 bytes, BW 1536 Kbit, DLY 20000 usec,
reliability 255/255, txload 5/255, rxload 245/255
Encapsulation FRAME-RELAY IETF, loopback not set
Keepalive set (10 sec)
LMI enq sent 8197, LMI stat recvd 8197, LMI upd recvd 0, DTE LMI up
you consider the actual bandwidth on the main serial interface (s0/3/0). you may want to configure bandwidth on the sub interface (s0/3/0.1) and monitor bandwidth via a network monitoring tool or using show interface command.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...