Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

Notification while redistributing with a route-map

Hello All,

Can anyone explain meaning of the below error message:

brse517(config-router-af)#redistribute static route-map SET-COMMUNITY-STATIC

% "SET-COMMUNITY-STATIC" used as redistribute static into bgp route-map, set extcommunity rt not supported

1 REPLY
New Member

Re: Notification while redistributing with a route-map

You could change the route target extended community attribute in the same way as the standard community attribute. However, setting extended community attributes through route maps applied to route redistribution, or to BGP neighbors, is not supported; this type of change must be implemented using export maps.

The following example shows the error that is produced if you try to change the route target through a route map.

Router(config-route-)# set extcommunity rt 100:100

% "ExtendedCommOut" used as BGP outbound route-map, set extcommunity rt not supported

217
Views
0
Helpful
1
Replies