Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

NSR disabled on neighbor due to TCP retransmissions

Hello,

I have a problem on ASR9K routing, i found this log on ASR9K , am not sure about the meanning of this ?

but i found the route record are slowly update to our routing table.

I hope you give me your recommendation for this problem.

Thanks in advanced.

%ROUTING-BGP-3-INITSYNC_PFX_MISMATCH : Neighbor: x.x.x.x State: Idle Flags: 0xa310000 vrf: default AFI: IPv4 Unicast Pfx received: 5230843 expected: 423616 - will retry once more

%ROUTING-BGP-3-NBR_NSR_DISABLED : NSR disabled on neighbor x.x.x.x due to Standby reset

%ROUTING-BGP-5-NBR_NSR_DISABLED_STANDBY : NSR disabled on neighbor x.x.x.x on standby due to Peer closing down the session (VRF: default)

%ROUTING-BGP-3-NBR_NSR_DISABLED : NSR disabled on neighbor x.x.x.x due to TCP retransmissions

%IP-TCP_NSR-5-DISABLED : y.y.y.y:41576 <-> x.x.x.x:179:: NSR disabled for TCP connection because Retransmission threshold exceeded

1626
Views
0
Helpful
0
Replies