Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

object tracking... can someone look over this?

All, I want to do object tracking between two ISPs, one attached to my serial interface of my router and another that goes off to a broadband. I want the serial interface to have all traffic, unless it goes down completely, which the broadband will take over. Can someone look at this config and tell me why this isnt working? With this config in place, I can not get Internet bound traffic out at all. I know it must be in the object tracking or static route statements, because I can put a default route to the next hop of the broadband by itself and I can get out then. Can someone help please? Thanks.

1 REPLY
Bronze

Re: object tracking... can someone look over this?

Hi,

I cannot see any NAT config ?

You should implement NAT overloading on

interface FastEthernet0/1.

BR,

Bjornarsb

100
Views
0
Helpful
1
Replies