Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

Bronze

Object tracking with Def Route

Track and sla is up but default route override is not working. Per below, I have a static btwn the 172 host across WAN and tracking it. I am using Lo172 on both side so when I do a shut on HQ Lo172 side, the track should go down and the default route for 192 net should override the current def route for 10 but does not . If I try changing the admin dist for 192 from 10 to 8, it just installs the 0/0 for 192 net into the routing table so is a manual override for the 0/0 for 10 net. I do not want a manual override but an dynamic auto override. When I do a sh ip route track...it appears to verify that tracking it on

Remote (172.16.1.2/32)--------------WAN/track-----------------HQ (172.16.1.1/32)

ip route 0.0.0.0 0.0.0.0 192.168.1.1 10 name TO-DSL-ROUTER track 10

ip route 0.0.0.0 0.0.0.0 10.10.1.1 9 name TO-S-CORE1-UK

R-MaryAxe#SH TRACK

Load for five secs: 2%/0%; one minute: 3%; five minutes: 3%

Time source is NTP, 00:44:41.819 GMT Sat Mar 6 2010

Track 10

  IP SLA 10 reachability

  Reachability is Up

    3 changes, last change 00:13:09

  Delay up 20 secs, down 60 secs

  Latest operation return code: OK

  Latest RTT (millisecs) 36

  Tracked by:

    STATIC-IP-ROUTING 0

R-MaryAxe#sh ip route track-table
Load for five secs: 2%/0%; one minute: 3%; five minutes: 3%
Time source is NTP, 00:52:01.832 GMT Sat Mar 6 2010

ip route 0.0.0.0 0.0.0.0 192.168.1.1 10 name TO-DSL-ROUTER track 10 state is [up]

nevermind  - it fix...i put the track on the wrong def route, should be on

ip route 0.0.0.0 0.0.0.0 10.10.1.1 9 name TO-S-CORE1-UK track 10

1 REPLY
Hall of Fame Super Silver

Re: Object tracking with Def Route

Hello Aamercado,

yes the track has to be on the primary route

I would also make the secondary route floating by using the AD parameter like

ip route 0.0.0.0 0.0.0.0 192.168.1.1 10 name TO-DSL-ROUTER 200

Hope to help

Giuseppe

253
Views
0
Helpful
1
Replies