Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

OER - Active Probing

Dear Experts,
I am going thru OER configuration. While coming across CREATION OF ACTIVE PROBES, I learned that ative probes are synthetic/simulated traffic using IP SLA features.
I also understood that 2 types are there viz. Learned probes & Configured Probes.
Configured Probes are created using command active-probe under oer master. Then what is the difference between configuring active probes using IP SLA MONITORING and using ACTIVE-PROBE command. Is both are same?
Thanks in advance
sairam
1 ACCEPTED SOLUTION

Accepted Solutions
Hall of Fame Super Blue

Re: OER - Active Probing

snarayanaraju wrote:

Dear Experts,
I am going thru OER configuration. While coming across CREATION OF ACTIVE PROBES, I learned that ative probes are synthetic/simulated traffic using IP SLA features.
I also understood that 2 types are there viz. Learned probes & Configured Probes.
Configured Probes are created using command active-probe under oer master. Then what is the difference between configuring active probes using IP SLA MONITORING and using ACTIVE-PROBE command. Is both are same?
Thanks in advance
sairam

Sairam

OER just uses IP SLA underneath the hood so to speak. So by configuring an active probe within OER you are actually using IP SLA monitoring, just that you don't have to explicitly type out all the ip sla configuration.

Jon

2 REPLIES
Hall of Fame Super Blue

Re: OER - Active Probing

snarayanaraju wrote:

Dear Experts,
I am going thru OER configuration. While coming across CREATION OF ACTIVE PROBES, I learned that ative probes are synthetic/simulated traffic using IP SLA features.
I also understood that 2 types are there viz. Learned probes & Configured Probes.
Configured Probes are created using command active-probe under oer master. Then what is the difference between configuring active probes using IP SLA MONITORING and using ACTIVE-PROBE command. Is both are same?
Thanks in advance
sairam

Sairam

OER just uses IP SLA underneath the hood so to speak. So by configuring an active probe within OER you are actually using IP SLA monitoring, just that you don't have to explicitly type out all the ip sla configuration.

Jon

New Member

Re: OER - Active Probing

Thanks Jon,

I got it. But now in this new screens I am not able to vote or rate yours solutions.

However I will rate full and I got the solution from your answer

sairam

476
Views
0
Helpful
2
Replies
CreatePlease to create content