I am interested in using OER to aggregate two ADSL from two ISPs. Can anyone explain if IPsec tunnels (from the router) would work over this, im confused whether this would load balance as there are two peer IPs?
Well, I can tell you that I'm having trouble getting it to work. That may very well be caused by my limited knowledge though.
I'm trying to get PPTP passthrough up and running.
I haven't even tried to get it to balance through OER, I would have been happy to get it to work on one of my two WAN links on a single 1800 router that has OER enabled.
I natted the 1723 port just fine through a route-map, and that seems to connect. However, the tunnel doesn't come up. It seems like the router doesn't know to which WAN interface the GRE packets have to be routed, and as far as I know GRE itself cannot be natted through a route-map.
If anyone knows where I could begin to solve this, I'd be very thankful...
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...