OER policy - Queue

[snarayanaraju]

Dear Experts,

I am configuring OER and I learned various ways of measuring the traffic and set threshold like delay, Max-xmit, Max-range, Throughput etc.

Is it possible to measure and change the traffic to another exit interface using the output queue of the interface. Putting in simple words. if serial 0/0 interfaces queue reached 80% of the configured value, the subsequent traffic should be diverted to serial 0/1.

I googled and checked with Cisco DOC CDs, but not clues.

Can you please help on this

regards,

sairam

[tomek0001]

Sairam

This can be done with the following commands:

oer master

border ip-address [key-chain key-chain-name]

interface type number external

max-xmit-utilization {absolute kbps | percentage value}

end

You can find more information on http://www.cisco.com/en/US/docs/ios/oer/configuration/guide/oer-trf_lnk_util_ps6441_TSD_Products_Configuration_Guide_Chapter.html#wp1054319

(please rate if helpful)

Let me know if that's what you are looking for.

Regards,

Tom