Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

on PA-4E1 Multilink is not working!

Hi,

I have one Cisco7606 with RSP720-3C-GE(12.2(33)SRD4) and one WS-X6582-2PA with PA-4E1g/75 on it. The problem is I cannot make multilink interface with the Serial interfaces on PA-4E1. It says " *Jun 16 09:21:38: %RP_MLP-4-PANOTSUPPORTED: Adding Link from unsupported PA, can
t add, giving control to RP"

here is some info:

Show inventory :


NAME: "module 4/0", DESCR: "G703/E1 Serial Port Adapter"
PID: Unknown           , VID:    , SN: xxxxxx

RTHK1#sh diagbus 4
Slot 4: Logical_index 8
        2 port adapter Enhanced FlexWAN controller
        Board is analyzed ipc ready
        HW rev 2.3, board revision C0
        Serial Number: xxxxxx Part number: xxxxx

        Slot database information:
        Flags: 0x2004   Insertion time: 0x16542A0 (00:39:56 ago)

        Controller Memory Size:
                192 MBytes CPU Memory
                63 MBytes Packet Memory
                255 MBytes Total on Board SDRAM
        Cisco IOS Software, cwlc Software (cwpa2-DW-M), Version 12.2(33)SRD4, RE
LEASE SOFTWARE (fc2)

        PA Bay 0 Information:
                G703 Serial PA, 4 ports
                EEPROM format version 1
                HW rev 1.01, Board revision F0
                Serial number: xxxxx  Part number: xxxxx

Slot 4: Logical_index 9
        2 port adapter Enhanced FlexWAN controller
        Board is analyzed ipc ready
        HW rev 2.3, board revision C0
        Serial Number: xxxxx Part number: xxxxx

        Slot database information:
        Flags: 0x2004   Insertion time: 0x1650338 (00:40:13 ago)

        Controller Memory Size:
                192 MBytes CPU Memory
                63 MBytes Packet Memory
                255 MBytes Total on Board SDRAM
        Cisco IOS Software, cwlc Software (cwpa2-DW-M), Version 12.2(33)SRD4, RE
LEASE SOFTWARE (fc2)

2 REPLIES

Re: on PA-4E1 Multilink is not working!

You already have your answer -

Jun 16 09:21:38: %RP_MLP-4-PANOTSUPPORTED

New Member

Re: on PA-4E1 Multilink is not working!

I knew that, but the problem is when I replace RSP with SUP720 it works fine!. This is confiusing me. What's difference between these Supvervisors...

400
Views
0
Helpful
2
Replies