Hi I configured the cisco to get with a static NAT to reach my internal WEB server at adress 10.10.10.231, from outside. It is well configured. I have a registered domain , and pings works allways ,(from outside the lan ) reach the router. The problem come when I use either IE or firefox, write my domain I can open the WEB page properly. But is occurs only one time.
If a close the session and try again, I can´t. The page is in blank.!! or open try to the web from another computer , I can´t see it.
The only way is to stop / start the web service and I can access again, buy again only one time... !!
To check if was a problem of WEB server I installed apache and IIS .. so there is not a problem with the WEB software. Internally in my LAN I can open the WEB page properly , not only one time..
is something missing into the cisco router conf to cause this problem
There is no firewall at all to avoid drop problems.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...