Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

You may experience some slow load times, errors, and slight inconsistencies. We ask for your patience as we finalize the launch. Thank you.

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our beta test area to get started.

New Member

OSPF ABR route filtering

Hi,

Area 0 is connectd to area 1 by two routers R1 and R2 area border routers. We need some routes to be sent to back bone area by router R1 and remaining all to be sent to backbone area by R2. so that when data from back bone , for some destinations will be sent to R1 and some will be sent via R2. This will form some kind of load balancing.

Please share the experience.

Any link on cisco.com is highly appreciable.

Thanks in advance.

Subodh

  • WAN Routing and Switching
2 REPLIES

Re: OSPF ABR route filtering

in your case you need to use OSPF ABR Type 3 LSA Filtering

see bellow link

http://www.cisco.com/en/US/docs/ios/12_2t/12_2t4/feature/guide/ftabrt3f.html

good luck

if helpful Rate

123
Views
10
Helpful
2
Replies