How is it possible to create OSPF adjaceny over PPPoE in a case when PPPoE server assigns IP add to PPPoE client? The issue I face is that PPPoE client creates /32 route (what is normal) same as PPPoE server. Since the neighbors are on different IP subnets, OSPF does not form adjacency . Is there any way to overcome this behavior?
A vague idea. Treat the pppoe connection as an ip unnumbered link and try seeing if the neighborship comes up. Iam assuming you have a static IP for your connection. You can add both the static IP and the remote PPPoE source (Loopback typically) in the network.
This document gives several answers on frequently asked questions for PFRv3 channel state behavior.
Q1: What are all the channel operational states from a BR (border role) perspective and what are the rules/conditions to be in each st...
The need was to reach an host inside a LAN through a VPN connection managed by the LAN gateway (Cisco 1921).
The LAN gateway performs NAT and there was a dedicate nat rule for the host i wanted to reach through VPN.
I couldn't connect to the hos...
We have 3 identical switches configured by someone else and would like to claim some of the Gigabit ports(G1/G2/G3/G4) for use on servers. When we try to change the wiring and configuration, we run in to connectivity issues. Attached is a des...