I had to setup and router with both protocols, im receiving the provider with the lan interface in area 1. I want change the configuration on my router to continous using ospf and additionaly i want setup other protocol like eigrp for other new provider.
Hi Edinson, my question is the network entry in the router eigrp 1 command is only the interface conected to the isp2?, can I select specific interfaces (or subnets) to participate in the dinamic routing (the entries in the router eigrp 1 command).
For example if I want the subnet 192.168.1.2 forward o route all the traffic to the isp2 , can i put this network in the network command?.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...