Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
New Member

ospf area issue

Hi all

In ospf process,they require inject a default route to area 4, should i configurate the area 4 is a stub or totally stub area?

one more a question:

if i wanna an area in ospf process can only receive the inter-area route and must not receive the External route, what should i do

thanks advance

2 REPLIES
Hall of Fame Super Blue

Re: ospf area issue

Hi

1) Configure as a totally stub area and only a default route will be injected into the area ie. no external or inter-area routes will be advertised into area 4

2) Configure as a stub area which will allow inter-area routes but not external routes.

HTH

Jon

Silver

Re: ospf area issue

If you have any connectivity behind the area 4 means rip or eigrp then you can make the area 4 as NSSA,. Else you can make the area 4 as total stub area. After doing this you will be reciving a one default O*E2 route.

regards

shivlu

92
Views
5
Helpful
2
Replies
CreatePlease to create content