11-24-2006 09:01 PM - last edited on 03-25-2019 03:13 PM by ciscomoderator
Hello expert,
I am trying to configure an ospf area range to summarize the routes in area 1:
1.1.8.0/24, 1.1.9.0/24, 1.1.10.0/24, 1.1.11.0/24
by using area 1 range 1.1.8.0 255.255.252.0
However, on the other ospf routers in area 0, I can see the summary route 1.1.8.0/22, and also the four /24 routes.
I am using 12.4 image, do I miss anything?
Thanks.
Solved! Go to Solution.
11-24-2006 09:12 PM - last edited on 04-13-2022 03:57 AM by Translator
Hi,
How many ABRs do you have between area 0 and area 1 ? If you only configure the
area range
command on one of the ABRs, then the other ABRs will still advertise the /24s.
Paresh
PS. Pls do remember to rate posts.
11-24-2006 09:12 PM - last edited on 04-13-2022 03:57 AM by Translator
Hi,
How many ABRs do you have between area 0 and area 1 ? If you only configure the
area range
command on one of the ABRs, then the other ABRs will still advertise the /24s.
Paresh
PS. Pls do remember to rate posts.
11-24-2006 09:28 PM - last edited on 04-13-2022 03:56 AM by Translator
Hi,
I think You have done the things correctly. is this configuration done on the router once it alredy had the above listed /24 routes in the database.
Is this a test setup. try clearing the routes manually and check if the router still lists them.
clear ip route
-amit singh
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide