lets say you have route 10.0.0.0 received from the remote router and you want to install that route in to the local router route table with the cost of 20 and metric type 1... then first of all you have to create the accesslist which will have statment allow for the network 10.0.0.0... now you have to creat the route map in order to match the ip address permited by accesslist...
now using the same route map you are installing or redistributing that route (10.0.0.0) wiht the metric type 1... so in your case you have accesslist 1 which permiting the network 10.0.0.0 (for example) now you are matching that route using the routemap "static-filter" and using the redistribute static command you are reidstributing that route in routing tabel with the type1...
Please remember, static routes that do not match your route-map will not be redistributed into OSPF. (There is an explicit deny at the end of every route-map. But of course you can permit everything using route-map static-filter permit 9999 command, or some other very high sequence number - the idea is for that sequence number to be the highest in that route map)
That means, for your configuration, that only static routes that match ACCESS-LIST 1 will be redistributed into your OSPF process (with already mentioned E1 type and Metric of 20)
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.