Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ospf config

hi team,

we have a ospf ring for our cdma network,which happens to be switched network.we have formed the ring using 4 hsw switch card in cisco1841 router.Now we r experiencing ping delay to one of our site in the ring.as per the ospf config,if one of the site is down ,it takes the alternate path,that's fine.how to enable rstp in the router switch port.

expecting ur reply

2 REPLIES

Re: ospf config

I dont think that the ether switch modules support RSTP. The faqs do not state it as a limitation but neither do they say it is supported

http://www.cisco.com/en/US/products/ps5855/products_qanda_item0900aecd8016c026.shtml

You can however configure the port a SPT portfast port

HTH

Narayan

New Member

Re: ospf config

The basic verification of layer 2 loop is to verify MAC address forwarding table. Check on what port each devices MAC are being learned.

100
Views
0
Helpful
2
Replies
CreatePlease to create content