Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Community Member

OSPF cost manipulation

I have a remote site that until recently was connected via L2L tunnel. We now have a DS3 to that site and I'd like to manipulate the cost of OSPF so that it picks the DS3 first and the tunnel second.

Can someone point me to a config example or a doc.

Thanks,

Brent

3 REPLIES

Re: OSPF cost manipulation

Super Bronze

Re: OSPF cost manipulation

On most(?) Cisco routers, OSFP will compute a cost derived by the configured (or assumed) bandwidth statement. You can configured a manual OSFP cost too, but using the bandwidth statement, all interfaces will recompute their cost if you change the OSPF reference bandwidth. (I.e. I think the management aspect is better using bandwidth statements.)

Community Member

Re: OSPF cost manipulation

Sorry guys.. the L2L tunnel is a PIX515 .. should have mentioned that .. hahaha .. my bad ..

any help would still be great!

544
Views
0
Helpful
3
Replies
CreatePlease to create content