07-13-2009 10:10 AM - edited 03-04-2019 05:25 AM
I have a remote site that until recently was connected via L2L tunnel. We now have a DS3 to that site and I'd like to manipulate the cost of OSPF so that it picks the DS3 first and the tunnel second.
Can someone point me to a config example or a doc.
Thanks,
Brent
07-13-2009 11:16 AM
you need ip ospf Cost under interfaces.
To avoid asymmetric routing, add this under both adjacent interfaces.
HTH
Sam
07-13-2009 12:27 PM
On most(?) Cisco routers, OSFP will compute a cost derived by the configured (or assumed) bandwidth statement. You can configured a manual OSFP cost too, but using the bandwidth statement, all interfaces will recompute their cost if you change the OSPF reference bandwidth. (I.e. I think the management aspect is better using bandwidth statements.)
07-13-2009 12:32 PM
Sorry guys.. the L2L tunnel is a PIX515 .. should have mentioned that .. hahaha .. my bad ..
any help would still be great!
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: