Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OSPF default-information originate

Hi all

I notice that BGP default-originate do nit pass thru filter list etc and thus cannot be filtered.

What about default-information originate, anyone know if this can be filtered or is it like bgp , it cannot be filtered?

Hope someone know the question

1 REPLY
Hall of Fame Super Silver

Re: OSPF default-information originate

Hello Alan,

you can use conditions to decide when to inject a default route in OSPF using a route-map to match some conditions like presence of some prefixes in routing table, ip next hop.

But once the default route is created it can be stopped only at the ingress of a stub area (any type of stub) because it is an external route.

(Actually some types of stub area injext an O IA default route inside the area at the ABR the router between area 0 and stub area)

A special case could be the injection of a default route inside an NSSA area with flag do not propagate to avoid translation to normal type 5 LSA at area border.

So actually it cannot be filtered but only conditioned.

Hope to help

Giuseppe

108
Views
5
Helpful
1
Replies