Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

OSPF- Distribute-list

Hi

Can any one tell me , why i am getting this msg on router only in OSPF

R1(config-router)#distribute-list 1 out serial 2/3

% Interface not allowed with OUT for OSPF

3 REPLIES
Hall of Fame Super Bronze

Re: OSPF- Distribute-list

"You cannot specify an interface name in OSPF. When used for OSPF, this feature applies only to external routes."

http://www.cisco.com/univercd/cc/td/doc/product/software/ios124/124cg/hirp_c/ch20/piconfig.htm#wp1001343

Hall of Fame Super Gold

Re: OSPF- Distribute-list

Vinod

Edison makes a good point about specifying an interface name in OSPF distribute list. I would like to go a bit deeper about the use of distribute list in OSPF. Unlike routing protocols like EIGRP or RIP which do advertise routes, OSPF advertises LSAs. Since a distribute list filters advertisement of routes it is not effective in filtering of LSAs and can not assigned outbound on an interface.

HTH

Rick

Bronze

Re: OSPF- Distribute-list

also....

The command distribute-list out works only on the routes being redistributed by the Autonomous System Boundary

Routers (ASBRs) into OSPF. It can be applied to external type 2 and external type 1 routes, but not to intra-area

and interarea routes.

arun ..:)

411
Views
6
Helpful
3
Replies
CreatePlease to create content