I have already running OSPF network between different locations. There are 3 locations named as A , B and C locations. The links between A & B are running OSPF1 process and links between C & A and C & B are running OSPF 2 process . Through redistribution, we have exchanged the routes between the ospf process. Now, we are going to put one more site in C location. We are expecting that there will be two links established between C & D and also From D location, one link goes to A and another link goes to B. also some conditons to be met while integrating the links from D. To reach A site from D, the only respective links to be taken and also to reach B from D site, the corresponding links be taken for traffic forwarding.
I need your help on how to integrate the new links from D with all the controlling.
Between A & C and B & C dual OSPF process are running and achived the routes filtering everything over Distance and E1 routes to install in the routing table. So pls help me to acheive the new link to network with all filering.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...