07-11-2010 09:50 AM - edited 03-04-2019 09:01 AM
Hi all,
I have set up two router with route port (two router with two links with equal cost) and running ospf to test ospf failover time. I get the result is about 4 sec.
Why it so fast. ospf not take 30 sec ?
07-11-2010 09:59 AM
Check your Hello times first...
if its 1 second than probably the result is correct it gives you Hold-down
timer at 3 to 4 second.
On Sun, Jul 11, 2010 at 10:20 PM, acbennyma <
07-11-2010 10:17 AM
Hi,
I haven't intended to tune the hello time and dead interval. On the other hand, I have checked the default dead interval is 40secconds. So why my result is just few seconds ?
thank!
07-11-2010 11:34 AM
Hi,
How are you checking the fail over ?
If its by shutting down the link or removing the cable, Ospf will NOT wait for hold interval to expire for obvious reasons !
You may delete the process on the other router and check this out, it will work in the desired way
HTH,
Discover and save your favorite ideas. Come back to expert answers, step-by-step guides, recent topics, and more.
New here? Get started with these tips. How to use Community New member guide