I have 3 routers in a classic triangle configuration connected with 1 STM1 each one. 2 routers have 2 STM1 between them. At the point of view of the un router that have 3 STM1, I need to load balancing between all interfaces.
OSPF supports only equal cost load balancing. You can use the interface command 'ip opsf cost' and configure the same value on all participating interfaces, forcing the router(s) to perform load balancing.
Anothet thing that you can do if you do not want to manipulate the cost is to use the bandwidth on the interfaces . Make sure you configure the same bandwidth on all the intercaes hence same cost so OSPF will perorm load balancing.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.