Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

OSPF ON FIBRE RING TOPOLOGY

Hello Folks,

I will keep it short and simple , here is the scenario:

1. got the dedicated fibre ring (single , not dual) covering almost 50 km and there are 24 layer 3 switches hooked up with it.

2:  want to run OSPF on this ring to keep the things simple and easy. 

3: thinking to have DR/BDR in my network.

4: got  different VLANS's in different subnets.

 

can someone send configuration example based on ring topology please?

your quick response will be very much appreciated.

 

Thanks,

mir

1 REPLY

spin up GNS3 and start

spin up GNS3 and start playing with it, then come with your questions.

Please remember to rate useful posts, by clicking on the stars below.

128
Views
0
Helpful
1
Replies
CreatePlease to create content