Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

OSPF on simple home setup

Hi mates :)

I'll appreciate your help on the setup;

Please see the OSPF1.jpg drawing which shows setup of active devices and PCs.

What I want is, all 6 PCs to ping each other

OSPF will be the routing protocol

questions:

1. would that setup work with the assigned IP addresses on shown setup?

Pls pay attention, serial ports on router arent used, ethernet ports are used as L3 ports, would that cause any trouble?

Tx in advance for helping :)

2 REPLIES
Hall of Fame Super Blue

Re: OSPF on simple home setup

Hi

Could you have another look at your jpg. You seem to be using 40.40.40.1 at least twice and some of the other addressing seems a bit amiss (PC1 & PC2 for example).

There will be no problem using the ethernet ports.

Have you already done a config for your layer 3 devices. If so could you include these as well.

Jon

New Member

Re: OSPF on simple home setup

hi John and tx for reply.

I am gonna draw new figure with IP addresses and put in to a new topic. tx for your answer on ethernet ports. :)

113
Views
5
Helpful
2
Replies
CreatePlease to create content