Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

OSPF priority issue

hello,

we have a 3662 router connected to both ATM Network and IP network using OSPF. the ATM network is considered the next-hop for the all ospf routes. my need is to force the routing through Ip Network using always OSPF.

Regards

3 REPLIES
Hall of Fame Super Silver

Re: OSPF priority issue

Hello Driss,

on the atm interface you can use

int atm x/y

ip ospf cost 1000

note:

verify current cost of routes with

sh ip route x.x.x.x

this in simple scenario can be enough unless the links are in different OSPF areas.

Hope to help

Giuseppe

New Member

Re: OSPF priority issue

hello,

thanks for reply

i have already applied it, but does not work. i noticed both static routes from both ATM and IP ? what does it mean ?

Re: OSPF priority issue

can you provide us examples, preferably your routing table

Please remember to rate useful posts, by clicking on the stars below.

104
Views
0
Helpful
3
Replies