I tested both suggestions, but it still same. Because I'm new to this routing protocol, I want to confirm with yours that whether all routes will show equal numbers of path when using "show ip route" ? I also get same result as above when using lesses routers. But these problems wouldn't happen when using eigrp routing protocol. So what are the possible errors in my configuration? Which is the best way to design such network ?
[toc:faq]The ProblemOn traditional switches whenever we have a trunk
interface we use the VLAN tag to demultiplex the VLANs. The switch needs
to determine which MAC Address table to look in for a forwarding
decision. To do this we require the switch to do...
[toc:faq]Introduction:Netdr is a tool available on a RSP720, Sup720 or
Sup32 that allows one to capture packets on the RP or SP inband. The
netdr command can be used to capture both Tx and Rx packets in the
software switching path. This is not a substitut...
IntroductionOSPF, being a link-state protocol, allows for every router
in the network to know of every link and OSPF speaker in the entire
network. From this picture each router independently runs the Shortest
Path First (SPF) algorithm to determine the b...