Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OSPF - Single Area 0 solution required

Hi All,

I am looking forward for a solution on OSPF Area0 case. The case looks like.

1. Site 1 connected Via MPLS-POP1 and running eBGP.

2. Site 2 connected via MPLS-POP2 and running eBGP.

The ASN used is the same.

3. Site-1 and site 2 are connected to switches on E1 link on ethernet.

2 REPLIES
New Member

Re: OSPF - Single Area 0 solution required

if your network has only two location i would suggest to run EIGPR rather then ospf,

Super Bronze

Re: OSPF - Single Area 0 solution required

Unclear what your issue is. Site-1 and Site-2 are connected by some kind of metro Ethernet? Can the two site not form an OSPF adjacency? Are the two sites in two different OSPF areas?

125
Views
0
Helpful
2
Replies