Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OSPF Stub Area setup

I'm setting up a stub area with 2 routers over a switch. I'm having a  problem with getting the adjacency through the switch, but I get it if I  use a crossover cable.

Besides the ports being active on the switch is there any other configuration that I need? i.e. a VLAN?

Thanks

1 ACCEPTED SOLUTION

Accepted Solutions
Cisco Employee

Re: OSPF Stub Area setup

Hello,

Please make sure that both ports where you have connected the routers are on

the same VLAN (same broadcast domain). Also, make sure that the switch

supports multicast traffic.

Hope this helps.

Regards,

NT

1 REPLY
Cisco Employee

Re: OSPF Stub Area setup

Hello,

Please make sure that both ports where you have connected the routers are on

the same VLAN (same broadcast domain). Also, make sure that the switch

supports multicast traffic.

Hope this helps.

Regards,

NT

169
Views
0
Helpful
1
Replies