Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Attention: The Community will be in read-only mode on 12/14/2017 from 12:00 am pacific to 11:30 am.

During this time you will only be able to see content. Other interactions such as posting, replying to questions, or marking content as helpful will be disabled for few hours.

We apologize for the inconvenience while we perform important updates to the Community.

New Member

OSPF traffic Control

Hi.

Please understand my poor english.

- OSPF Network

link1

+----------+ 10.2.2.1/24

10.1.1.1/24 R1 + + R2

+----------+ 10.22.22.2/24

link2

- R1 have network 10.1.1.1/24

- R2 have two networks

10.2.2.0/24 10.22.22.0/24

- 10.1.1.0/24, 10.2.2.0/24 10.22.22.0/24 in Area0

- traffic of 10.2.2.1/24 from R1 to R2 must flow in link1

- traffic of 10.22.22.1/24 from R1 to R2 must flow in link2

- is it possible by OSPF?

is there any possible easy method?

i just know that Metric can't change by OSPF in same area

1 REPLY
Hall of Fame Super Gold

Re: OSPF traffic Control

If you want to route by source address, OSPF cannot do this, use PBR.

296
Views
0
Helpful
1
Replies
CreatePlease to create content