I dont think there's a feature in ospf that allows filtering of Type 5 LSA, though there's a feature that allows filtering of Type 3 LSA btw areas.
Usually, to avoid an area from receiving Type 5 LSAs in a certain area, that area would usually be configured as a stub area. As u might already know, type 5 LSAs are flooded throughout the entire OSPF domain, except stubs, TSAs, Totally-NSSAs.
I might be wrong, but i haven't yet found a way to filter type 5 LSAs without configuring an area to be a stub.
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...