08-14-2013 11:27 AM - edited 03-04-2019 08:45 PM
Hi, I was wondering if anyone has a configuration example or documentation regarding configuring OTV in unicast mode on an ASR1000 router, I haven't been able to find any from Cisco, I appreciate it.
08-14-2013 07:19 PM
Hi Borman,
Did you check the example in ASR 1k configuration guide?
http://www.cisco.com/en/US/docs/ios-xml/ios/wan_otv/configuration/xe-3s/wan-otv-adj-server.html
HTH,
Lei Tian
Sent from Cisco Technical Support iPhone App
08-15-2013 07:42 AM
Yes, thanks and I did see the Unicast part, there are only a couple of configuration statements under the interface overlay configuration so I'm assuming I should just remove the multicast portion of the previous multicast configuration example and use these two statements instead? so everything else stays the same?
08-15-2013 08:23 PM
Hi,
Yes, only need the interface commands. The configure for internal interface,join interface are similar, without the multicast control/data group.
HTH,
Lei Tian
Sent from Cisco Technical Support iPhone App
12-17-2013 05:53 AM
Just in case you are looking at configurations related to OTV [unicast], you can visit one of the blogs I have written related to OTV unicast-core specifically for ASR1K.
http://stayinginit.blogspot.in/2013/12/basic-unicast-overlay-transport.html
Find answers to your questions by entering keywords or phrases in the Search bar above. New here? Use these resources to familiarize yourself with the community: