Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

OTV in Unicast mode on ASR1000X

Hi, I was wondering if anyone has a configuration example or documentation regarding configuring OTV in unicast mode on an ASR1000 router, I haven't been able to find any from Cisco, I appreciate it.

4 REPLIES
Cisco Employee

Re: OTV in Unicast mode on ASR1000X

Hi Borman,

Did you check the example in ASR 1k configuration guide?
http://www.cisco.com/en/US/docs/ios-xml/ios/wan_otv/configuration/xe-3s/wan-otv-adj-server.html

HTH,
Lei Tian

Sent from Cisco Technical Support iPhone App

New Member

OTV in Unicast mode on ASR1000X

Yes, thanks and I did see the Unicast part, there are only a couple of configuration statements under the interface overlay configuration so I'm assuming I should just remove the multicast portion of the previous multicast configuration example and use these two statements instead? so everything else stays the same?

Cisco Employee

Re: OTV in Unicast mode on ASR1000X

Hi,

Yes, only need the interface commands. The configure for internal interface,join interface are similar, without the multicast control/data group.

HTH,
Lei Tian

Sent from Cisco Technical Support iPhone App

Cisco Employee

OTV in Unicast mode on ASR1000X

Just in case you are looking at configurations related to OTV [unicast], you can visit one of the blogs I have written related to OTV unicast-core specifically for ASR1K.

http://stayinginit.blogspot.in/2013/12/basic-unicast-overlay-transport.html

413
Views
0
Helpful
4
Replies