Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
cancel
Community Member

OTV Join-Interface: loopback or port-channel

 

(Moved this post from Data Center community to Network Infrastructure community as no reply from DC community after a week.)

Hello, OTV expert,

 

Not sure which is better for OTV Join-Interface, loopback or Port-Channel.

Would like to hear your thoughts please.

 

Thanks

Cedar

 

Everyone's tags (1)
2 REPLIES
Cisco Employee

Hi Cedar,Kindly note that if

Hi Cedar,

Kindly note that if you are using ASR1000's as your edge-device, they do not allow you to configure loopback interface as your join-interface. You can use port-channel as the join-interface.

I am not much aware in case of nexus. I will get back to you on the same.

Thanks,

Aries

 

 

Community Member

Thanks Aries. Look forward to

Thanks Aries. Look forward to your investigation.

704
Views
0
Helpful
2
Replies
CreatePlease to create content