Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

ouput queue drops on E1 link

Hi,

have a serial int with output queue drops increasing slowly, however the tx, rx loads appear low, its not a busy link. any idea what could be causing this?

1 REPLY

Re: ouput queue drops on E1 link

Hello,

rx and tx load are averaged over at least 30 seconds (default: 5 minutes!). So short term overload situations will not be visible. Assume a server with 256kB window size connected with GE. It could overload the link for a few seconds leading to a few dropped packets. rx or tx load would not increase substantially.

Hope this helps! Please rate all posts.

Regards, Martin

113
Views
3
Helpful
1
Replies