Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

out of band management using pots line

Hello folks, I'm trying to configure a 2801 with WIC-1AM-V2 for out of band management using pots line. I need a little guidance.

Thanks, in advanced.

JP

2 REPLIES
Hall of Fame Super Silver

Re: out of band management using pots line

Hello Joseph,

if you want to implement an out of band management for emergency to be used only when needed you need to use dial on demand routing.

you can find the basis of DDR in 12.4 dial config guide

http://www.cisco.com/en/US/docs/ios/dial/configuration/guide/dia_preparing_ddr_ps6350_TSD_Products_Configuration_Guide_Chapter.html

for the WIC-1AM-V2 it has a built-in analog POTS modem

follow the following document

http://www.cisco.com/en/US/docs/ios/12_3t/12_3t14/feature/guide/gt12pwi8.html#wp1053415

as you can see from router point of view it is seen as an interface Asynch.

you will use a separate address plan for out of band management so that the device can be reached = called or it can call the NOC center

a floating static route completes this scenario using PPP authentication and call screening (specifying the calling number that can be accepted)

Hope to help

Giuseppe

Re: out of band management using pots line

Just an opinion but to be truely OOB I like to use eternal modems.

902
Views
0
Helpful
2
Replies
CreatePlease to create content