I have a weird issue . . . On a router connected to a passport via an ATM card, I was seeing the link flapping, and I was able to see these flaps occuring while in the router and in the logs. After checking the interface, I was seeing increasing output drops even though the link was not over utilized nor was there any QoS setup causing the drops. To be on the safe side, The card has been replaced on the router. I am no longer seeing the link flapping on the router (using term mon or in the log) yet the output drops are still increasing, and our monitoring tool is still reporting link flaps. At this point I am trying to find out what could be causing these Output drops when there is no QoS setup and I am no seeing the "no Buffer" counter incrementing:
lalaland#sho int atm1/0
ATM1/0 is up, line protocol is up
Hardware is RS8234 ATM DS3
MTU 4470 bytes, sub MTU 4470, BW 45000 Kbit, DLY 190 usec,
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.