You can not assign the same IP subnet to 2 different interfaces. Since you have 6 available IPs that equals to a /29 subnet, so you can make 2 /30s out of your /29 and then assign one /30 per interface.
Thanks. But if I change it to /30 mask ,then Dailer0 interface may not communciate with the my ISP/Internet as its currently sits on 255.255.255.248 subnet, if I change to to 255.255.255.252 then will I beak the internet connectivity ?
Do my ISP need to change anything from there end to make this configuration working?
Can I simply assign /32 mask on Dialer interfacce and /30 mask reserve /30 mask for sonicwall and C1841 fa0/0.
Is this an ADSL connection to your service provider? If this is the case, can you use "ip address negotiated" under interface dialer and let the provider take care of that? You usually don't assign IP to a dialer interface.
This is SDSL connection to my ISP. I understand I can use IP address negotiated command under dailer interface but my problem is I need to assign 2nd public IP on the router' Fa0/0 interface( on same subnet) to communicate with the Sonicwall using public IP.
So something like below.
C1841-> two interfaces
Dailer 0 connected to interface ,
Ip unnumbered fastethernet0/0
Fa0/0 IP address 188.8.131.52/29 which is connecting back to sonicwall using 184.108.40.206
I Just need to establish layer 3 connecticity using public IP but problem is I can't configure routers fa0/0 with public IP if dailer interface already has a IP address on the same range.
This is actually a pretty cool feature, i didn't even know it existed until I was looking for a solution to advertise a subnet (prefix in BGP talk), only if a certain condition existed. This is exactly what conditional advertisements does
j ai une question j ai achete un routeur cisco 887VA-k9 , je le configuré avec la configuration ci- dessous
si je le lier avec mon pc portable sur l un de ses ports directement ça marche toute est bien ( la connexion internet + m...
Attached policy provides CLI access to the Cisco 4G router over text messaging. Two files are in the attached .tar file:
2. PDF with instructions on how to load and use the .tcl file.