Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements
Webcast-Catalyst9k
New Member

P2P 1841 Configuration Question

I have a question that I need some help on. I have two offices in different states. Both routers connect using 256 frame relay. I am using WIC-1DSU-T1-V2 modules in each router. I will put these both on the same subnet so they will see each other. Is there a document to help me configure these routers? Any advice would be helpful.

Thanks in advance.

3 REPLIES
Silver

Re: P2P 1841 Configuration Question

Hi,

http://www.cisco.com/en/US/tech/tk713/tk237/tech_configuration_examples_list.html

"Configuring Basic Frame Relay"

"Configuring Point-to-Point Frame Relay Subinterfaces"

about FR:

http://www.cisco.com/en/US/products/sw/iosswrel/ps1831/products_configuration_guide_chapter09186a0080087d01.html

Hope this helps

Please let me know

Regards

Andrea

New Member

Re: P2P 1841 Configuration Question

Thanks, that is what I was looking for.

I needed info on:

Speed for Timeslots (Valid options: 64/56)

Framing (Valid options: esf/sf)

Timeslots (Valid options: 1-24)

Linecode (Valid options: b8zs/ami)

encap frame-relay (Valid options: IETF/CISCO)

frame-relay lmi-type (Valid options:

ansi/CISCO/Q933A)

Silver

Re: P2P 1841 Configuration Question

Hi,

http://www.cisco.com/cgi-bin/Support/Cmdlookup/home.pl

for a specific question, please let me know

HTH

Andrea

107
Views
0
Helpful
3
Replies
CreatePlease to create content