Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PA-MC-8E1+ module AL LED stays on

I have upgraded a 4 port serial card on a flexwan module in a 7600 to a PA-MC-8E1 in the same bay. The module comes up, I can configure 4 of the channels and all data passes without controller or Serial errors. However the AL LED stays on on the module. I have shut down all controllers and removed all cables and the LED still stays on. I have also repeated the no power enable followed by a power enable on the flexwan module and still the LED stays on RED. How can I check if this is an actual error or not.

297
Views
0
Helpful
0
Replies