Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. If you'd prefer to explore, try our test area to get started. And see here for current known issues.

New Member

PA-T3+

Does the PA-T3+ has an onboard DSU?

The docmentation says

"The PA-T3+ supports several types of integrated data service units (DSUs). "

and give a list of DSUs like kentrox

Does this mean I need an external DS3 DSU to go with this card.

If so , what is the advantage of that card compared to the HSSI PA-H which is cheaper

Thanks

http://www.cisco.com/en/US/customer/products/hw/modules/ps2033/products_module_installation_guide_chapter09186a008010b29e.html#1032423

1 ACCEPTED SOLUTION

Accepted Solutions
Silver

Re: PA-T3+

DSU is internal. When it references Kentrox these are the modes the DSU can emulate. Card is fairly easy to work with. See the configuring tab on the weblink you have above.

Good luck

Steve

2 REPLIES
Silver

Re: PA-T3+

DSU is internal. When it references Kentrox these are the modes the DSU can emulate. Card is fairly easy to work with. See the configuring tab on the weblink you have above.

Good luck

Steve

New Member

Re: PA-T3+

I agree with the above. They are pretty simple. Once you insert the card, you get a serial interface created.

interface Serial6/0

no ip address

shutdown

dsu bandwidth 44210

framing c-bit

cablelength 10

serial restart-delay 0

Then you just plug in the coax. Depending on telco, you may have to adjust the framing, but that is all.

91
Views
0
Helpful
2
Replies