I have a remote site that i've configured for Frame Relay. (it is a standard DS1 over a channalized DS3 back to a cisco 8510 with a frame relay DS3 adapter.)I noticed that if I send standard ICMP packet accross the serial interface I get "normal" response times. But once I start sending larger packets accross the line, my ping times increase exponentially. Just so happens that if I send packets 128 bytes or less, ping times are fine, 129bit packets and my ping times double, 257 bytes or higher and my ping times double again. 1500 bytes and my ping times are really bad. My MTU is set for 1500 byte packets.
My thought was packets are possibly fragmenting.
I don't know if this is enough information but any thoughts?
Specifies whether or not the Don't Fragment (DF) bit is to be set on the ping packet. If yes is specified, the Don't Fragment option does not allow this packet to be fragmented when it has to go through a segment with a smaller maximum transmission unit (MTU), and you will receive an error message from the device that wanted to fragment the packet. This is useful for determining the smallest MTU in the path to a destination. Default : no.
Thank you for your reply. I was able to resolve my issue. Thanks for you input as I learned something new.
My solution was this:
There was a misconfiguration on the Cisco 8510. When the Frame Relay to pvc mapping was done, a connection table was not selected. This caused all the connections to have a PCR (Peak Cell Rate) of 34000bps.
Hi everyone, I would like to thank you in advance for any help you can provide a newcomer like myself!
Im studying the 100-105 book by Odom and am currently on the topic of Port security. I purchased a used 2960 and I'm trying to follow a...
While deploying a number of 18xx/2802/3802 model access points (APs), which run AP-COS as their operating platform. It can be observed on some occasions that while many of their access points were able to join the fabric WLC withou...
I am going to design and build an LAN network under a tunnel underground with long distance between the switches.
I will have 2 Catalyst switches and 8 Industrial IE3000, and they will be connected with fiber.
For now I am planning on use Layer-2 s...