I am going to install a new cisco 2821 Router in a educational institution.
I am 4 e1 ports installed and will get 8 mbps from service provider.When i am connecting to the remote site (Service Provider Network) then my e1 ports frequently gets up and down status of my e1 ports very frquently ( i seen the status through show ip int brief commands).Wireless media is also checked and there is no problem with the media. I have taken the same router to other network (my service provider) it was working perfect there. Now Service Provider is saying to provide proper earth/ ground to the router (Although i have already provided it). Please tell me what would be problem. and Also tell me how much earth/ ground (in ohms) should i provide to Router.
Is it possible that router ceate such problem if i dont provide proper earth?
Question We run asr9001 with XR 6.1.3, and we have a very long delay to
login w/ SSH 1 or 2 to the device compare to IOS device. After
investigation, the there is 1s delay between the client KEXDH_INIT and
the server (XR) KEXDH_REPLY. After debug ssh serv...
Introduction The purpose of this document is to demonstrate the Open
Shortest Path First (OSPF) behavior when the V-bit (Virtual-link bit) is
present in a non-backbone area. The V-bit is signaled in Type-1 LSA only
if the router is the endpoint of one or ...
Hi, I am seeing quite a few issues with patch install and wanted to
share my experience and workaround to this. Login to admin via CLI, then
access root with the “shell” command Issue “df –h” and you’ll probably
see the following directory full or nearly ...