Cisco Support Community
cancel
Showing results for 
Search instead for 
Did you mean: 
Announcements

Welcome to Cisco Support Community. We would love to have your feedback.

For an introduction to the new site, click here. And see here for current known issues.

New Member

packets flow in VLANs

I want to check the packet flow in subinterfaces. Is there any other command than sh VLANs?

I want to see if round robin load balancing is happening in the subinterfaces.

sh VLans output is as follows:

Vlan ID 10

Protocol Configured IP

Address W.X.Y.Z

Recieved 155083

Transmitted 82970

Vlan ID 20

Protocol Configured IP

Address W.X.Y1.Z

Recieved 1198

Transmitted 51328

It seems that one of the subinterfaces transmites and recieves more than the other.

Can anyone please help me if there are other ways to check the packet flow in VLANs ?

2 REPLIES
New Member

Re: packets flow in VLANs

I am not sure what you mean by load balancing. You have two vlans which have unique traffic flow characteristics. The traffic flow is based on the traffic for the vlan.

Re: packets flow in VLANs

Dear tigist,

as there is IP address configured on the SVI interfaces for each VLAN, just enable Netflow by use --> ip route-cache flow - under the SVI interface (Interface Vlan10, interface VLAN20) then you can catch the traffic vlow from each of VLANS by using show ip cache flow.

Here is the config:

Interface vlan10

ip address x.x.x.x

ip route-cache flow

Interface vlan20

ip address x.x.x.x

ip route-cache flow

r1#show ip cache flow

Please rate helpful posts.

Best Regards,

Mounir Mohamed

331
Views
4
Helpful
2
Replies